Cisco Catalyst 4500 Series Command Reference Guide

2-274
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
hw-module power
hw-module power
To turn the power off on a slot or line module, use the no hw-module power command. To turn the power
back on, use the hw-module power command.
hw-module [slot | module] number power
no hw-module [slot | module] number power
Syntax Description
Defaults After a boot up, the power is on.
Command Modes Global configuration mode
Command History
Usage Guidelines After you enter no hw-mod mod x power command and OIR the linecard, the configuratio persists and
is valid for any slot in the chassis it is applied to.
Examples This example shows how to shut off power to a module in slot 5:
Switch(config)# no hw-module slot 5 power
Related Commands
slot (Optional) Specifies a slot on a chassis.
module (Optional) Specifies a line module.
number Slot or module number.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.2(18)EW Add slot and module keywords.
Command Description
clear hw-module slot password Clears the password on an intelligent line module.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E