Cisco Catalyst 4500 Series - Pagp Port-Priority

2-504
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
pagp port-priority
pagp port-priority
To select a port in hot standby mode, use the pagp port-priority command. To return to the default
value, use the no form of this command.
pagp port-priority priority
no pagp port-priority
Syntax Description
Defaults Port priority is set to 128.
Command Modes Interface configuration mode
Command History
Usage Guidelines The higher the priority, the better the chances are that the port will be selected in the hot standby mode.
Examples This example shows how to set the port priority:
Switch(config-if)# pagp port-priority 45
Switch(config-if)#
Related Commands
priority Port priority number; valid values are from 1 to 255.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
pagp learn-method Learns the input interface of the incoming packets.
show pagp Displays information about the port channel.