Cisco Catalyst 4500 Series Command Reference Guide

2-821
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show mac access-group interface
show mac access-group interface
To display the ACL configuration on a Layer 2 interface, use the show mac access-group interface
command.
show mac access-group interface [interface interface-number]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines The valid values for the port number depend on the chassis used.
Examples This example shows how to display the ACL configuration on interface fast 6/1:
Switch# show mac access-group interface fast 6/1
Interface FastEthernet6/1:
Inbound access-list is simple-mac-acl
Outbound access-list is not set
Related Commands
interface (Optional) Specifies the interface type; valid values are ethernet, fastethernet,
gigabitethernet, tengigabitethernet, pos, atm, port-channel, and ge-wan.
interface-number (Optional) Specifies the port number.
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
access-group mode Specifies the override modes (for example, VACL
overrides PACL) and the non-override modes (for example,
merge or strict mode).

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E