Cisco Catalyst 4500 Series - Debug Ip Dhcp Snooping Packet

2-155
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug ip dhcp snooping packet
debug ip dhcp snooping packet
To debug the DHCP snooping messages, use the debug ip dhcp snooping packet command. To disable
the debugging output, use the no form of this command.
debug ip dhcp snooping packet
no debug ip dhcp snooping packet
Syntax Description This command has no arguments or keywords.
Defaults Debugging of snooping packet is disabled.
Command Modes Privileged EXEC mode
Command History
Examples This example shows how to enable the debugging for the DHCP snooping packets:
Switch# debug ip dhcp snooping packet
Switch#
This example shows how to disable the debugging for the DHCP snooping packets:
Switch# no debug ip dhcp snooping packet
Switch#
Related Commands
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
debug ip dhcp snooping event Debugs the DHCP snooping events.