EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #897 background imageLoading...
Page #897 background image
2-839
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show mac-address-table static
show mac-address-table static
To display the static MAC address table entries only, use the show mac-address-table static command.
show mac-address-table static [address mac_addr | interface type number | protocol protocol |
vlan vlan_id]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines For the MAC address table entries that are used by the routed ports, the routed port name is displayed in
the “vlan” column not the internal VLAN number.
The keyword definitions for the protocol argument are as follows:
assigned specifies the assigned protocol entries.
ip specifies the IP protocol.
ipx specifies the IPX protocols.
other specifies the other protocol entries.
address mac_addr (Optional) Specifies a 48-bit MAC address to match; the valid format is
H.H.H.
interface type number (Optional) Specifies an interface to match; valid values for type are
fastethernet, gigabitethernet, and tengigabitethernet.
protocol protocol (Optional) Specifies a protocol. See the “Usage Guidelines” section for
more information.
vlan vlan_id (Optional) Displays the entries for a specific VLAN; valid values are from
1 to 4094.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(12c)EW Added support for extended VLAN addresses.
12.2(25)EW Added support for the 10-Gigabit Ethernet interface.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals