Cisco Catalyst 4500 Series Command Reference Guide

2-21
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
arp access-list
arp access-list
To define an ARP access list or add clauses at the end of a predefined list, use the arp access-list
command.
arp access-list name
Syntax Description
Defaults This command has no default settings.
Command Modes Global configuration mode
Command History
Examples This example shows how to define an ARP access list named static-hosts:
Switch(config)# arp access-list static-hosts
Switch(config)#
Related Commands
name Specifies the access control list name.
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
deny Denies an ARP packet based on matches against the DHCP
bindings.
ip arp inspection filter vlan Permits ARPs from hosts that are configured for static IP when
DAI is enabled and to define an ARP access list and applies it to
a VLAN.
permit Permits an ARP packet based on matches against the DHCP
bindings.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E