Cisco Catalyst 4500 Series Command Reference Guide

2-493
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
nmsp
nmsp
To configure Network Mobility Services Protocol (NMSP) on the switch, use the nmsp command. This
command is available only when your switch is running the cryptographic (encrypted) software image.
Use the no form of this command to return to the default setting.
nmsp {enable | {notification interval {attachment | location} interval-seconds}}
no nmsp {enable | {notification interval {attachment | location} interval-seconds}}
Syntax Description
Defaults NMSP is disabled, NMSP notification interval attachment and NMSP notification interval location
defaults are 30 seconds.
Command Modes Global configuration mode
Command History
Usage Guidelines Use the nmsp global configuration command to enable the switch to send encrypted NMSP location and
attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples This example shows how to enable NMSP on a switch and set the location notification time to 10
seconds:
Switch(config)# nmsp enable
Switch(config)# nmsp notification interval location 10
Switch(config)#
Related Commands
enable Enables the NMSP features on the switch.
notification interval Specifies the NMSP notification interval.
attachment Specifies the attachment notification interval.
location Specifies the location notification interval.
interval-seconds Duration in seconds before a switch sends the location or attachment
updates to the MSE. The range is 1 to 30; the default is 30.
Release Modification
12.2(52)SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
clear nmsp statistics Clears the NMSP statistic counters.
nmsp attachment suppress Suppress reporting attachment information from a specified
interface.
show nmsp Displays the NMSP information.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E