Cisco Catalyst 4500 Series Command Reference Guide

2-1125
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
vmps retry
vmps retry
To configure the per-server retry count for the VLAN Query Protocol (VQP) client, use the vmps retry
command. To return to the default setting, use the no form of this command.
vmps retry count
no vmps retry
Syntax Description
Defaults The retry count is 3.
Command Modes Global configuration mode
Command History
Usage Guidelines You can verify your setting by entering the show vmps command and examining information in the
Server Retry Count row.
Examples This example shows how to set the retry count to 7:
Switch(config)# vmps retry 7
Related Commands
count Number of attempts to contact the VLAN Membership Policy Server (VMPS) by the
client before querying the next server in the list; valid values are from 1 to 10.
Release Modification
12.1(13)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
show vmps Displays the VLAN Query Protocol (VQP) version,
reconfirmation interval, retry count, VLAN Membership Policy
Server (VMPS) IP addresses, current servers, and primary
servers.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E