Cisco Catalyst 4500 Series Command Reference Guide

2-290
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
interface range
interface range
To run a command on multiple ports at the same time, use the interface range command.
interface range {vlan vlan_id - vlan_id} {port-range | macro name}
Syntax Description
Defaults This command has no default settings.
Command Modes Global configuration mode
Interface configuration mode
Command History
Usage Guidelines You can use the interface range command on the existing VLAN SVIs only. To display the VLAN SVIs,
enter the show running config command. The VLANs that are not displayed cannot be used in the
interface range command.
The values that are entered with the interface range command are applied to all the existing VLAN
SVIs.
Before you can use a macro, you must define a range using the define interface-range command.
All configuration changes that are made to a port range are saved to NVRAM, but the port ranges that
are created with the interface range command do not get saved to NVRAM.
You can enter the port range in two ways:
• Specifying up to five port ranges
• Specifying a previously defined macro
You can either specify the ports or the name of a port-range macro. A port range must consist of the same
port type, and the ports within a range cannot span the modules.
You can define up to five port ranges on a single command; separate each range with a comma.
When you define a range, you must enter a space between the first port and the hyphen (-):
interface range gigabitethernet 5/1 -20, gigabitethernet4/5 -20.
vlan vlan_id - vlan_id Specifies a VLAN range; valid values are from 1 to 4094.
port-range Port range; for a list of valid values for port-range, see the “Usage
Guidelines” section.
macro name Specifies the name of a macro.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(12c)EW Support for extended VLAN addresses added.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E