Cisco Catalyst 4500 Series Command Reference Guide

2-153
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug ipc
debug ipc
To debug the IPC activity, use the debug ipc command. To disable the debugging output, use the no form
of this command.
debug ipc {all | errors | events | headers | packets | ports | seats}
no debug ipc {all | errors | events | headers | packets | ports | seats}
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Examples This example shows how to enable the debugging of the IPC events:
Switch# debug ipc events
Special Events debugging is on
Switch#
Related Commands
all Enables all IPC debugging.
errors Enables the IPC error debugging.
events Enables the IPC event debugging.
headers Enables the IPC header debugging.
packets Enables the IPC packet debugging.
ports Enables the debugging of the creation and deletion of ports.
seats Enables the debugging of the creation and deletion of nodes.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
undebug ipc (same as no debug
ipc)
Disables debugging output.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E