2-1133
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
vtp domain
vtp domain
To configure the administrative domain name for a device, use the vtp domain command.
vtp domain domain-name
Syntax Description
Defaults This command has no default settings.
Command Modes VLAN configuration mode
Command History
Usage Guidelines When you define the domain-name, the domain name is case sensitive and can be from 1 to 32 characters.
You must set a domain name before you can transmit any VTP advertisements.
Even if you do not set a domain name, the device will leave the no-management-domain state upon
receiving the first VTP summary packet on any port that is currently trunking.
If the device receives its domain from a summary packet, it resets its configuration revision number to
zero. Once the device leaves the no-management-domain state, it can never be configured to reenter the
number except by cleaning NVRAM and reloading.
Examples This example shows how to set the devices administrative domain:
Switch(vlan-config)# vtp domain DomainChandon
Switch(vlan-config)#
Related Commands
domain-name Name of the domain.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
show vtp Displays VTP statistics and domain information.
vtp (global configuration
mode)
Configures the name of a VTP configuration storage file.
To Next Page
Loading...
Need help?
General
