Cisco Catalyst 4500 Series - Destination (Netflow-Lite Exporter Submode)

2-186
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
destination (netflow-lite exporter submode)
destination (netflow-lite exporter submode)
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
To specify a destination address in netflow-lite submode, use the destination command. To delete an
exporter, use the no form of this command.
destination destination-address
no destination destination-address
Syntax Description
Defaults None
Command Modes netflow-lite exporter submode
Command History
Usage Guidelines One of the mandatory parameters for a minimally configured exporter along with the source Layer 3
interface and the UDP destination port of the collector.
Examples This example shows how to specify a destination address in netflow-lite submode:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
destination-address Specifies a destination address of a NetFlow-lite collector.
Release Modification
15.0(2)SG Support for this command was introduced on on the Catalyst 4948E and
Catalyst 4948E-F Ethernet switches.