Cisco Catalyst 4500 Series Command Reference Guide

2-916
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show running-config
show running-config
To display the module status and configuration, use the show running-config command.
show running-config [module slot]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines In some cases, you might see a difference in the duplex mode displayed when you enter the show
interfaces command and the show running-config command. If you do see a difference, the duplex
mode displayed in the show interfaces command is the actual duplex mode that the interface is running.
The show interfaces command shows the operating mode for an interface, while the show
running-config command shows the configured mode for an interface.
The show running-config command output for an interface may display a duplex mode configuration
but no configuration for the speed. When no speed is displayed in the output, it indicates that the
interface speed is configured to be auto and that the duplex mode shown becomes the operational setting
once the speed is configured to something other than auto. With this configuration, it is possible that the
operating duplex mode for that interface does not match the duplex mode shown with the show
running-config command.
Examples This example shows how to display the module and status configuration for all modules:
Switch# show running-config
03:23:36:%SYS-5-CONFIG_I:Configured from console by consolesh runn
Building configuration...
Current configuration:3268 bytes
!
version 12.1
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Switch
!
!
power supplies required 1
ip subnet-zero
module slot (Optional) Specifies the module slot number; valid values are from 1 to 6.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E