2-1094
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ttl (netflow-lite exporter submode)
ttl (netflow-lite exporter submode)
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
To specify a ttl value for the NetFlow-lite collector, use the ttl command. To delete the value, use the no
form of this command.
ttl ttl-value
no ttl ttl-value
Syntax Description
Defaults 254
Command Modes netflow-lite exporter submode
Command History
Usage Guidelines The ttl limit takes effect only when the export packets are based on IPv4. It has no effect on IPv6.
Examples This example shows how to specify a ttl value for the NetFlow-lite collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
Display the exporter
Switch# show netflow-lite exporter exporter1
Netflow-lite Exporter exporter1:
Network Protocol Configuration:
ttl-value Specifies a ttl value for the NetFlow-lite collector.
Valid values are from 1 to 254.
Release Modification
15.0(2)SG Support for this command was introduced on the Catalyst 4948E and
Catalyst 4948E-F Ethernet switches.