Cisco Catalyst 4500 Series Command Reference Guide

2-540
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
power inline logging global
power inline logging global
To enable console messages that show when a PoE device has been detected and to show when a PoE
device has been removed, use the power inline logging global command.
power inline logging global
Syntax Description This command has no arguments or keywords.
Defaults Disabled
Command Modes Global configuration mode
Command History
Usage Guidelines Be aware of the potential for console flooding if this command is used on a switch connected to several
PoE devices.
Examples This example shows how to globally enable PoE status messaging on each interface:
To enable PoE event logging, you use the logging event poe-status global command:
Switch# conf terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# power inline logging global
Switch(config)# int gigabitEthernet 5/5
Switch(config-if)# shut
Switch(config-if)#
*Oct 17 12:02:48.407: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi5/5: PD removed
Switch(config-if)# no shut
Switch(config-if)#
*Oct 17 12:02:54.915: %ILPOWER-7-DETECT: Interface Gi5/5: Power Device detected: IEEE PD
Related Commands
Release Modification
15.0(2)SG2/
XE 3.2.2SG
Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
logging event link-status global (global
configuration)
Changes the default switch-wide global link-status event
messaging settings.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E