2-874
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show pagp dual-active (virtual switch)
show pagp dual-active (virtual switch)
To display dual-active detection information, use the show pagp dual-active command in EXEC mode.
show pagp [group-number] dual-active
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Examples The following example shows how to display dual-active detection information:
Router# show pagp dual-active
PAgP dual-active detection enabled: Yes
PAgP dual-active version: 1.1
Channel group 1
Dual-Active trusted group: Yes
Channel group 2
Dual-Active trusted group: Yes
Channel group 3 dual-active detect capability w/nbrs
Dual-Active trusted group: No
Dual-Active Partner Partner Partner
Port Detect Capable Name Port Version
Fa1/2/33 No None None N/A
Router#
The following example shows how to display dual-active detection information for a specific port
channel:
Router# show pagp dual-active
PAgP dual-active detection enabled: Yes
PAgP dual-active version: 1.1
Channel group 3 dual-active detect capability w/nbrs Dual-Active trusted group: No
Dual-Active Partner Partner Partner
Port Detect Capable Name Port Version
Fa1/2/33 No None None N/A
Channel group 4
Dual-Active trusted group: Yes
No interfaces configured in the channel group
Channel group 5
Dual-Active trusted group: Yes
Channel group 5 is not participating in PAGP
Channel group 10 dual-active detect capability w/nbrs Dual-Active trusted group: Yes
Dual-Active Partner Partner Partner
Port Detect Capable Name Port Version
group-number (Optional) Channel-group number. Range: 1 to 256 with a maximum of 64 values.
Release Modification
Cisco IOS XE 3.4.0SG and
15.1(2)SG
Support for this command was introduced on the Catalyst 4500 series
switch.
To Next Page
Loading...
