Cisco Catalyst 4500 Series - Redundancy Reload

2-588
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
redundancy reload
redundancy reload
To force a reload of one or both supervisor engines, use the redundancy reload command.
redundancy reload {peer | shelf}
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines Before using this command, refer to the “Performing a Software Upgrade” section of the
Catalyst 4500
Series Switch Cisco IOS Software Configuration Guide for additional information.
The redundancy reload shelf command conducts a reboot of both supervisor engines. The modules are
reset.
Examples This example shows how to manually reload one or both supervisor engines:
Switch# redundancy reload shelf
Switch#
Related Commands
peer Reloads the peer unit.
shelf Reboots both supervisor engines.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch
(Catalyst 4507R only).
Command Description
redundancy Enters the redundancy configuration mode.
show redundancy Displays redundancy facility information.