EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #466 background imageLoading...
Page #466 background image
2-408
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
mab
mab
To enable and configure MAC authorization bypass (MAB) on a port, use the mab command in interface
configuration mode. To disable MAB, use the no form of this command.
mab [eap]
no mab [eap]
Note The mab command is totally independent of the effect of the dot1x system-auth control command.
Syntax Description
Command Default Disabled
Command Modes Interface configuration mode
Command History
Usage Guidelines When a port is configured for MAB as a fallback method, it operates in a typical dot1X method until a
configurable number of failed attempts to request the identity of the host. The authenticator learns the
MAC address of the host and uses that information to query an authentication server to see whether this
MAC address will be granted access.
Examples The following example shows how to enable MAB on a port:
Switch(config-if)# mab
Switch(config-if)#
The following example shows how to enable and configure MAB on a port:
Switch(config-if)# mab eap
Switch(config-if)#
The following example shows how to disable MAB on a port:
Switch(config-if)# no mab
Switch(config-if)#
eap (Optional) Specifies that a full EAP conversation should be used, as opposed to
standard RADIUS Access-Request, Access-Accept conversation.
Release Modification
12.2(50)SG Support for this command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals