Cisco Catalyst 4500 Series - Destination Address

2-188
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
destination address
destination address
To configure the destination e-mail address or URL to which Call Home messages will be sent, use the
destination address command.
destination address {email email-address | http url}
Syntax Description
Defaults This command has no default settings.
Command Modes cfg-call-home-profile
Command History
Usage Guidelines To enter profile call-home configuration submode, use the profile command in call-home configuration
mode.
When entering the https:// destination URL for the secure server, you must also configure a trustpoint
CA.
Examples This example shows how to set the destination to the e-mail address callhome@cisco.com:
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# destination address email callhome@cisco.com
Related Commands
email email-address Specifies the destination e-mail address in 1 to 200 characters.
http url Specifies the destination HTTP URL in 2 to 200 characters.
Release Modification
12.2(52)SG Support was introduced on the Catalyst 4500 series switch.
Command Description
destination message-size-limit bytes Configures a maximum destination message size for the
destination profile.
destination preferred-msg-format Configures a preferred message format.
destination transport-method Enables the message transport method.
profile Enters profile call-home configuration submode
subscribe-to-alert-group all Subscribes to all available alert groups.
subscribe-to-alert-group configuration Subscribes this destination profile to the Configuration
alert group.
subscribe-to-alert-group diagnostic Subscribes this destination profile to the Diagnostic alert
group.