Cisco Catalyst 4500 Series Command Reference Guide

2-364
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip wccp redirect
Examples The following example shows how to configure a session in which reverse proxy packets on Ethernet
interface 3/1 are being checked for redirection and redirected to a Cisco Cache Engine:
Switch(config)# ip wccp 99
Switch(config)# interface gigabitethernet 3/1
Switch(config-if)# ip wccp 99 redirect out
The following example shows how to configure a session in which HTTP traffic arriving on
GigabitEthernet interface 3/1 is redirected to a Cache Engine:
Switch(config)# ip wccp web-cache
Switch(config)# interface gigabitethernet 3/1
Switch(config-if)# ip wccp web-cache redirect in
Related Commands Command Description
ip wccp check services all Configures an interface on a router to enable or disable the
reception of IP multicast packets for Web Cache
Communication Protocol (WCCP).
ip wccp group-listen Configures an interface on a router to enable or disable the
reception of IP multicast packets for Web Cache
Communication Protocol (WCCP).
ip wccp redirect exclude in Enables redirection exclusion on an interface.
show ip interface Displays the usability status of interfaces that are configured
for IP.
show ip wccp Displays the WCCP global configuration and statistics.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E