Cisco Catalyst 4500 Series - Page 154

2-96
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
class-map
Examples This example shows how to configure the class map called class1 with one match criterion, which is an
access list called 103:
Switch# configure terminal
Switch(config)# access-list 103 permit any any dscp 10
Switch(config)# class-map class1
Switch(config-cmap)# match access-group 103
Switch(config-cmap)# exit
Switch#
This example shows how to delete the class1 class map:
Switch# configure terminal
Switch(config)# no class-map class1
Switch#
You can verify your settings by entering the show class-map privileged EXEC command.
Related Commands Command Description
class Specifies the name of the class whose traffic policy you want to
create or change.
match (class-map
configuration)
Defines the match criteria for a class map.
policy-map Creates a policy map that can be attached to multiple ports to
specify a service policy and to enter policy-map configuration
mode.
show class-map Displays class map information.