Cisco Catalyst 4500 Series Command Reference Guide

2-998
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
spanning-tree mst configuration
Whenever you change an MST configuration submode parameter, it can cause a loss of connectivity. To
reduce the number of service disruptions, when you enter the MST configuration submode, you are
changing a copy of the current MST configuration. When you are done editing the configuration, you
can apply all the changes at once by using the exit keyword, or you can exit the submode without
committing any change to the configuration by using the abort keyword.
In the unlikely event that two users enter a new configuration at exactly at the same time, this message
is displayed:
Switch(config-mst)# exit
% MST CFG:Configuration change lost because of concurrent access
Switch(config-mst)#
Examples This example shows how to enter the MST configuration submode:
Switch(config)# spanning-tree mst configuration
Switch(config-mst)#
This example shows how to reset the MST configuration to the default settings:
Switch(config)# no spanning-tree mst configuration
Switch(config)#
Related Commands Command Description
instance Maps a VLAN or a set of VLANs to an MST instance.
name Sets the MST region name.
revision Sets the MST configuration revision number.
show spanning-tree mst Displays MST protocol information.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E