2-1038
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
switch convert mode (virtual switch)
Examples The following example shows how to configure a device in the distribution layer as a standalone switch
that has a switch number of 1:
Router1# switch convert mode virtual
This command will convert all interface names to naming convention "interface-type
chassis-number/slot/port", save the running config to startup-config and reload the
switch.
Do you want proceed? [yes/no]: yes
Converting interface names
Building Configuration...
[OK]
Saving converted configuration to bootflash: ...
Destination filename [startup-config.converted_vs-20070723-235834]?
To Next Page
Loading...
