Cisco Catalyst 4500 Series - Page 1214

Index
IN-6
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
destination (netflow-lite exporter submode)
command 2-186
device-sensor filter-list command 2-196
device-sensor filter-list dhcp command 2-199
device-sensor filter-spec command 2-201
device-sensor notify command 2-203
DHCP
clearing database statistics 2-110
DHCP bindings
configuring bindings 2-311
deny ARP packet based on matches 2-184
permit ARP packet based on matches 2-508
DHCP snooping
clearing binding entries 2-107
clearing database 2-109
displaying binding table 2-739
displaying configuration information 2-738
displaying status of DHCP database 2-743
displaying status of error detection 2-690
enabling DHCP globally 2-310
enabling IP source guard 2-352
enabling on a VLAN 2-320
enabling option 82 2-315, 2-317
enabling option-82 2-322
enabling rate limiting on an interface 2-318
enabling trust on an interface 2-319
establishing binding configuration 2-311
renew binding database 2-591
store generated bindings 2-313
diagnostic fpga soft-error recover command 2-205
diagnostic test
bootup packet memory 2-673
displaying attributes 2-667
display module-based results 2-669
running 2-207
show results for TDR 2-653
testing conditions of copper cables 2-1080
displaying error disable recovery 2-691
displaying inline power status 2-891
displaying monitoring activity 2-158
displaying PoE policing and monitoring status 2-899
displaying SEEPROM information
GBIC 2-701
displaying SPAN session information 2-942, 2-1022
document conventions 1-xxiv
document organization 1-xxiii
DoS
CoPP
attaching policy map to control plane 2-616
displaying policy-map class information 2-877
entering configuration mode 2-132
removing service policy from control plane 2-616
entering
CoPP configuration mode 2-132
DOS attack
protecting system’s resources 2-296
dot1x credentials (global configuration) command 2-211
drop threshold, Layer 2 protocol tunneling 2-393
dscp (netflow-lite exporter submode command 2-232
DSCP rewrite for IP packets
enable 2-579
dual-active detection (virtual switch) command 2-234
dual-active recovery ip address command 2-236
dual-capable port
selecting a connector 2-463
duplex mode
configuring autonegotiation on an interface 2-238
configuring full duplex on an interface 2-238
configuring half duplex on an interface 2-238
dynamic ARP inspection
preventing 2-296
Dynamic Host Configuration Protocol
See DHCP
E
EAP
restarting authentication process 2-223