Index
IN-16
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
traffic classifications
trust states 2-1092
setting the trust state 2-579
specifying flow-based match criteria 2-457
Supervisor Engine 6-E
setting CoS 2-622
setting DSCP 2-625
setting precedence values 2-628
setting QoS group identifiers 2-631
QoS CoS
configuring for tunneled Layer 2 protocol
packets
2-392
quality of service
See QoS
question command 1-1
queueing information
displaying 2-905
queue limiting
configuring packet limits 2-581
R
Rapid PVST
switching between PVST and MST 2-994
re-authenticating 802.1X-enabled ports 2-227
re-authentication
periodic 2-228
set the time 2-230
reauthentication, enabling 2-35
reboots
restoring bindings across 2-311
redundancy
accessing the main CPU 2-583
changing from active to standby supervisor
engine
2-587
displaying information 2-909
displaying ISSU config-sync failure
information
2-913
displaying redundancy facility information 2-909
displaying RF client list 2-909
displaying RF operational counters 2-909
displaying RF states 2-909
enabling automatic synchronization 2-72
forcing switchover to standby supervisor
engine
2-587
mismatched command listing 2-585
set the mode 2-464
synchronizing the route processor
configurations
2-451
related documentation 1-xxiii
remote-id, setting for an interface 2-558
remote-id, setting for an interface VLAN range 2-559
remote SPAN
See RSPAN
renew commands
ip dhcp snooping database 2-591
rep admin vlan command 2-592
rep block port command 2-593
rep lsl-age-timer command 2-597
rep preempt delay command 2-599
rep preempt segment command 2-601
rep segment command 2-602
rep stcn command 2-605
resetting PVLAN trunk
setting switchport to trunk 2-1049
retry failed authentiation, configuring 2-26
rj45 connector, selecting the connector 2-463
ROM monitor mode
summary 1-6
Route Processor Redundancy
See redundancy
router, set to become ANCP client 2-18
RPF
disabling IPv4 exists-only checks 2-354
enabling IPv4 exists-only checks 2-354
RPR
set the redundancy mode 2-464
RSPAN
To Next Page
Loading...
