Cisco Catalyst 4500 Series Command Reference Guide

2-133
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
control-plane
! Define aggregate control plane service for the active Route Processor.
Switch(config)# macro global apply system-cpp
Switch(config)# control-plane
Switch(config-cp)# service-police input system-cpp-policy
Switch(config-cp)# exit
Related Commands Command Description
class Specifies the name of the class whose traffic policy you want to
create or change.
class-map Creates a class map to be used for matching packets to the class
whose name you specify and to enter class-map configuration
mode.
match access-group (refer to
the Cisco IOS Release 12.2
Command Reference)
Configures the match criteria for a class map on the basis of the
specified access control list (ACL).
policy-map Creates a policy map that can be attached to multiple ports to
specify a service policy and to enter policy-map configuration
mode.
service-policy (interface
configuration)
Attaches a policy map to an interface.
show policy-map
control-plane
Displays the configuration either of a class or of all classes for the
policy map of a control plane.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E