2-277
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
hw-module uplink mode
Examples This example shows how to enable shared-backplane uplink mode:
Switch(config)# hw-module uplink mode shared-backplane
A reload of the active supervisor is required to apply the new configuration.
Switch(config)# exit
Switch#
This example shows how to disable shared-backplane uplink mode:
Switch(config)# no hw-module uplink mode shared-backplane
A reload of the active supervisor is required to apply the new configuration.
Switch(config)# exit
Switch#
This example shows how to display the current state of uplink-mode:
Switch# show hw-module uplink
Active uplink mode configuration is Default
(will be Shared-backplane after next reload)
A reload of active supervisor is required to apply the new configuration.
Related Commands Command Description
show hw-module uplink Displays hardware-module uplink information.
To Next Page
Loading...
