Cisco Catalyst 4500 Series - Page 360

2-302
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip arp inspection validate
Examples This example show how to enable the source MAC validation:
Switch(config)# ip arp inspection validate src-mac
Switch(config)# end
Switch# show ip arp inspection vlan 1
Source Mac Validation : Enabled
Destination Mac Validation : Disabled
IP Address Validation : Disabled
Vlan Configuration Operation ACL Match Static ACL
---- ------------- --------- --------- ----------
1 Enabled Active
Vlan ACL Logging DHCP Logging
---- ----------- ------------
1 Deny Deny
Switch#
Related Commands Command Description
arp access-list Defines an ARP access list or adds clauses at the end of a
predefined list.
show ip arp inspection Displays the status of dynamic ARP inspection for a
specific range of VLANs.