Cisco Catalyst 4500 Series Command Reference Guide

2-353
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip verify source
This example shows how to enable IP port security with IP-MAC filters on a Layer 2 access port:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# ip device tracking
Switch(config)# interface fastEthernet 4/3
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 1
Switch(config-if)# ip device tracking maximum 5
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security maximum 5
Switch(config-if)# ip verify source tracking port-security
Switch(config-if)# end
You can verify your settings by entering the show ip verify source privileged EXEC command.
Related Commands Command Description
ip device tracking maximum Enables IP port security binding tracking on a Layer 2 port.
ip dhcp snooping Globally enables DHCP snooping.
ip dhcp snooping information option Enables DHCP option 82 data insertion.
ip dhcp snooping limit rate Configures the number of the DHCP messages that an
interface can receive per second.
ip dhcp snooping trust Enables DHCP snooping on a trusted VLAN.
ip source binding Adds or delete a static IP source binding entry.
show ip dhcp snooping Displays the DHCP snooping configuration.
show ip dhcp snooping binding Displays the DHCP snooping binding entries.
show ip source binding Displays IP source bindings that are configured on the
system.
show ip verify source Displays the IP source guard configuration and filters on a
particular interface.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E