2-360
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip wccp check services all
Note The ip wccp check services all command is a global WCCP command that applies to all services and is
not associated with a single service.
Examples The following example shows how to configure all WCCP services:
Router(config)# ip wccp check services all
Related Commands Command Description
ip wccp Enables support of the specified WCCP service for participation in a service
group.
ip wccp group-listen Configures an interface on a router to enable or disable the reception of IP
multicast packets for Web Cache Communication Protocol (WCCP).
ip wccp redirect Enables packet redirection on an inbound or outbound interface using Web
Cache Communication Protocol (WCCP).
ip wccp redirect exclude
in
Configure an interface to exclude packets received on an interface from
being checked for redirection.
ip wccp version Specifies which version of WCCP you wish to use on your router.
To Next Page
Loading...
