Cisco Catalyst 4500 Series Command Reference Guide

2-481
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
monitor session
learning (Optional) Enables host learning on ingress-enabled destination
ports.
remote vlan vlan_id Specifies an RSPAN source or destination session on a switch.
source Specifies a SPAN source.
Port-channel interface-number Specifies a port-channel interface; valid values are from 1 to 64.
cpu Causes traffic received or sent from the CPU to be copied to the
destination of the session.
queue queue_id (Optional) Specifies that only traffic received on the specific
CPU subqueue should be copied to the destination of the
session. Valid values are from 1 to 64, or by the following
names: all, control-packet, esmp, mtu-exceeded,
unknown-port-vlan-mapping, unknown-sa, acl input, acl input
copy, acl input error, acl input forward, acl input punt, acl
output, acl output copy, acl output error, acl output forward, acl
output punt, l2-forward, adj-same-if, bridge-cpu, ip-option,
ipv6-scope-check-fail, l2-src-index-check-fail, mcast-rpf-fail,
non-arpa, router-cpu, ttl-expired, ucast-rpf-fail, l3-forward,
forward, glean, receive.
acl (Optional) Specifies input and output ACLs; valid values are
from 14 to 20.
input Specifies input ACLs; valid values are from 14 to 16.
error Specifies the ACL software errors.
log/copy Specifies packets for ACL logging.
punt Specifies packets punted due to overflows.
rx Specifies monitoring received traffic only.
output Specifies output ACLs; valid values are from 17 to 20.
l2-forward (Optional) Layer 2 or Layer 3 exception packets.
bridge-cpu Specifies packets bridged to CPU.
ip-option Specifies packets with an IP option.
ipv6-scope-check-fail Specifies IPv6 packets with scope-check failures.
l2-src-index-check-fail Specifies IP packets with mismatched SRC MAC and SRC IP
addresses.
mcast-rpf-fail Specifies IPv4/IPv6 multicast RPF failures.
non-arpa Specifies packets with non-ARPA encapsulation.
router-cpu Specifies software routed packets.
ttl-expired Specifies IPv4 routed pacekts exceed TTL.
adj-same-if Specifies packets routed to the incoming interface.
bridged Specifies Layer 2 bridged packets.
1 Specifies packets with the highest priority.
2 Specifies packets with the a high priority.
3 Specifies packets with the a medium priority.
4 Specifies packets with the a low priority.
ucast-rpf-fail Specifies IPv4/IPv6 Unicast RPF failures.
all (Optional) all queues.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E