Cisco Catalyst 4500 Series - Page 593

2-535
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
power inline
Examples This example shows how to set the inline-power detection and power for the inline-power-capable
interfaces:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 4/1
Switch(config-if)# power inline auto
Switch(config-if)# end
Switch#
This example shows how to disable the inline-power detection and power for the inline-power-capable
interfaces:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 4/1
Switch(config-if)# power inline never
Switch(config-if)# end
Switch#
This example shows how to set the permanent Power over Ethernet allocation to 8000 mW for Fast
Ethernet interface 4/1 regardless what is mandated either by the 802.3af class of the discovered device
or by any CDP packet that is received from the powered device:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 4/1
Switch(config-if)# power inline consumption 8000
Switch(config-if)# end
Switch#
This example shows how to pre-allocate Power over Ethernet to 16500 mW for Gigabit Ethernet
interface 2/1 regardless of what is mandated either by the 802.3af class of the discovered device or by
any CDP packet that is received from the powered device:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet 2/1
Switch(config-if)# power inline static max 16500
Switch(config-if)# end
Switch#
Related Commands Command Description
show power Displays information about the power status.