Cisco Catalyst 4500 Series - Page 662

2-604
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
rep segment
This example shows how to enable REP on a port and identify the port as the REP secondary edge port:
Switch (config)# interface GigabitEthernet1/1
Switch (config-if)# rep segment 100 edge
You can verify your settings by entering the show interfaces rep privileged EXEC command. To verify
which port in the segment is the primary edge port, enter the show rep topology privileged EXEC
command.
Related Commands Command Description
show interfaces rep
[detail]
Displays REP configuration and status for all interfaces or the specified
interface.
show rep topology
[detail]
Displays information about all ports in the segment, including which one was
configured and selected as the primary edge port.