Cisco Catalyst 4500 Series Command Reference Guide

2-636
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
shape (interface configuration)
All ports on the 24-port modules and the 48-port modules are multiplexed through a Stub ASIC. Some
examples of ports multiplexed through a Stub ASIC are as follows:
• 10/100 ports on the WS-X4148-RJ45 module
• 10/100/1000 ports on the WS-X4124-GB-RJ45 module
• 10/100/1000 ports on the WS-X4448-GB-RJ45 module
Examples This example shows how to configure a maximum bandwidth (70 percent) for the interface fa3/1:
Switch(config)# interface fastethernet3/1
Switch(config-if)# tx-queue 3
Switch(config-if-tx-queue)# shape 70m
Switch(config-if-tx-queue)#

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E