Cisco Catalyst 4500 Series Command Reference Guide

2-834
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show mac-address-table multicast
Related Commands Command Description
show mac-address-table address Displays the information about the MAC-address table.
show mac-address-table aging-time Displays MAC address table aging information.
show mac-address-table count Displays the number of entries currently in the MAC
address table.
show mac-address-table dynamic Displays the dynamic MAC address table entries only.
show mac-address-table interface Displays the MAC address table information for a specific
interface.
show mac-address-table protocol Displays the MAC address table information that is based
on the protocol.
show mac-address-table static Displays the static MAC address table entries only.
show mac-address-table vlan Displays information about the MAC address table for a
specific VLAN.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E