Cisco Catalyst 4500 Series - Page 928

2-870
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show nmsp
This is an example of output from the show nmsp capability command:
Switch# show nmsp capability
NMSP Switch Capability
------------------------
Service Subservice
----------- --------------
Attachment Wired Station
Location Subscription
Switch#
This is an example of output from the show nmsp notification interval command:
Switch# show nmsp notification interval
NMSP Notification Intervals
----------------------------------
Attachment notify interval: 30 sec (default)
Location notify interval: 30 sec (default)
Switch#
This is an example of output from the show nmsp statistics connection and show nmsp statistics
summary commands:
Switch# show nmsp statistics connection
NMSP Connection Counters
----------------------------------
Connection 1:
Connection status: UP
Freed connection: 0
Tx message count Rx message count
----------------------- -----------------------
Subscr Resp: 1 Subscr Req: 1
Capa Notif: 1 Capa Notif: 1
Atta Resp: 1 Atta Req: 1
Atta Notif: 0
Loc Resp: 1 Loc Req: 1
Loc Notif: 0
Unsupported msg: 0
Switch#
Switch# show nmsp statistics summary
NMSP Global Counters
------------------------
Send too big msg: 0
Failed socket write: 0
Partial socket write: 0
Socket write would block: 0
Partial socket write: 0
Failed socket read: 0
Socket read would block: 0
Transmit Q full: 0
Max Location Nofity Msg: 0
Max Attachement Notify Msg: 0
Max TX Q Size: 0
Switch#