Cisco Catalyst 4500 Series Command Reference Guide

2-884
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show policy-map interface vlan
Class-map: c1 (match-all)
0 packets
Match: ip dscp af11 (10)
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
Switch#
The following example shows a configuration on a Supervisor Engine 6-E:
interface gigabitethernet3/1
vlan-range 100
service-policy in p1
This example shows how to display policy-map statistics on VLAN 100 on the FastEthernet interface:
Switch# show policy-map interface gigabitethernet 3/1 vlan 100
GigabitEthernet3/1 vlan 100
Service-policy input: p1
Class-map: c1 (match-all)
0 packets
Match: ip dscp af11 (10)
police:
rate 128000 bps, burst 4000 bytes
conformed 0 packets, 0 bytes; action:
transmit
exceeded 0 packets, 0 bytes; action:
drop
conformed 0 bps, exceeded 0 bps
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
Switch#
Related Commands Command Description
service-policy (interface configuration) Attaches a policy map to an interface.
show policy-map interface Displays the statistics and configurations of the input and
output policies that are attached to an interface.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E