Cisco Catalyst 4500 Series Command Reference Guide

2-938
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show switch virtual (virtual switch)
Examples The following example shows how to display configuration and status information for the VSS:
• In virtual switch mode without skipping config-register:
Router# show switch virtual
Switch mode : Virtual Switch
Virtual switch domain number : 1
Local switch number : 2
Local switch operational role: Virtual Switch Active
Peer switch number : 1
Peer switch operational role : Virtual Switch Standby
Router#
• In virtual switch mode with skipping config-register but not yet rebooted:
Router# show switch virtual
Switch mode : Virtual Switch
Virtual switch domain number : 1
Local switch number : 2
Local switch operational role: Virtual Switch Active
Peer switch number : 1
Peer switch operational role : Virtual Switch Standby
Warning: Config-register set or will be set to skip configuration 0x2142 in the next
reload.
Change config-register; otherwise, switch will be boot in Standalone mode with some
default config.
Router#
• In standalone mode without skipping config-register:
Router# show switch virtual
Switch Mode : Standalone
Not in Virtual Switch mode due to:
Domain ID is not configured
Router#
• In standalone mode with skipping config-register:
Router# show switch virtual
Switch Mode : Standalone
Not in Virtual Switch mode due to:
Domain ID is not configured
Warning: config-register is set to skip parse 0x2142 in RP or SP
Use [show boot] on RP/SP to verify.
Router#
The following example shows how to display the virtual switch link information:
Router# show switch virtual link
VSL Status : UP
VSL Uptime : 4 hours, 26 minutes
VSL SCP Ping : Pass (or Fail) OK (or Not OK)
VSL ICC (Ping) : Pass (or Fail)
VSL Control Link : Te1/3/1
Router#
The following example shows how to display the virtual switch link counter information:
Router# show switch virtual link counters
Port InOctets InUcastPkts InMcastPkts InBcastPkts
Po10 66340451 190415 15637 112069
Te1/3/1 66981250 194528 15770 112072
Po20 42116619 92926 16406 128593
Te2/2/1 42117401 92932 16406 128593
Port OutOctets OutUcastPkts OutMcastPkts OutBcastPkts

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E