Cypress EZ-USB FX3 User Manual

EZ-USB FX3 Technical Reference Manual, Document Number: 001-76074 Rev. *F 129
General Programmable Interface II (GPIF II)
Figure 7-11. LD_DATA_COUNT Action Settings Dialog Box
The following parameters are associated with this action:
■ Counter type: Up counter/Down counter-The counter can be configured to count in ascending/descending order.
■ Counter load value-The initial count loaded when this action is performed.
■ Counter limit value-The count value at which the event should be generated.
■ Reload counter on reaching limit-The count load value can be reloaded when the count limit value is hit by selecting this
parameter.
■ Counter mask event-If this option is not selected, a firmware event is generated when the counter limit is reached.
■ Counter step value-The counter step value that should be added/subtracted each time the COUNT_DATA action is used.
7.4.1.9 Action - LD_CTRL_COUNT
This action loads the counter with initial settings. The initial settings are loaded when the state machine starts. This value
needs to be same in all states within a given state machine diagram. Multiple values are not allowed.
Figure 7-12. LD_CTRL_COUNT Action Settings Dialog Box
The following parameters are associated with this action:

Cypress EZ-USB FX3 Specifications

General

Brand	Cypress
Model	EZ-USB FX3
Category	Controller
Language	English