Cypress EZ-USB FX3 User Manual

EZ-USB FX3 Technical Reference Manual, Document Number: 001-76074 Rev. *F 271
GCTL_WAKEUP_EN
0xE0050004
10.5.1 GCTL_WAKEUP_EN (continued)
8 EN_UIB_DM Enables wakeup when the USB2 D+ line transitions to from 0 to 1 or from 1 to 0 (CONNECT in host
mode).
This wakeup source does not work from standby mode.
7 EN_UIB_DP Enables wakeup when the USB2 D+ line transitions to from 1 to 0 (USB RESUME) or from 0 to 1
(CONNECT in host mode).
This wakeup source does not work from standby mode.
6 EN_UART_CTS Enables wakeup from the UART_CTS pin. Wakeup occurs when the level set in POL_UART_CTS is
detected.
5 EN_GPIO[44] Enables wakeup from the GPIO[44] pin (card insertion). Wakeup occurs when the level set in
POL_GPIO[44] is detected.
4 EN_GPIO[47] Enables wakeup from the GPIO[47] pin (SD1). Wakeup occurs when the level set in POL_GPIO[47]
is detected.
3 EN_GPIO[34] Enables wakeup from the GPIO[34] pin (SD0). Wakeup occurs when the level set in POL_GPIO[34]
is detected.
2 EN_PIB_CLK Enables wakeup from the PIB_CLK pin. Wakeup occurs on any change on this pin after wakeup.
1 EN_PIB_CMD Enable wakeup from a CMD5 on the PIB_CMD pin. This wakeup source does not work from standby
mode. This wakeup source works from suspend only when an external 32-kHz clock source is
present.
0 EN_PIB_CTRL0 Enables wakeup from the PIB CTL0 pin (CE# typically). Wakeup occurs on any change on this pin
after wakeup.

Cypress EZ-USB FX3 Specifications

General

Brand	Cypress
Model	EZ-USB FX3
Category	Controller
Language	English