DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
257
Figure 6-61 OSPFv2 Interface Settings Window
The fields that can be configured in OSPF Interface Settings are described below:
Parameter Description
VRF Name
Enter the name of the VRF instance here. This name can be up to 12 characters
long. Click the Select VRF button to select a pre-configured VRF instance that will
be used here.
Area ID
Enter the OSPFv2 area ID here.
Network IP Address
Enter the network IPv4 address here.
Network Mask
Enter the network IPv4 subnet mask here.
Click the Apply button to accept the changes made.
The fields that can be configured in OSPF Interface Table are described below:
Parameter Description
VRF Name
Enter the name of the VRF instance here. This name can be up to 12 characters
long. Click the Select VRF button to select a pre-configured VRF instance that will
be used here.
Interface Name
Enter the name of the interface to be displayed here.
Click the Find button to locate a specific entry based on the information entered.
Click the Show Detail button to view more detailed information about the entry.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Show Detail button, the following page will appear.
To Next Page
Loading...
