DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
326
After clicking the Please Select button, the following page will appear.
Figure 6-158 IP Multicast Global Settings (Please Select) Window
Select the ACL and click the OK button to use the selected access list.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IP Multicast Route Settings
This window is used to display and configure the IP multicast route settings.
To view the following window, click L3 Features > IP Multicast Routing Protocol > IPMC > IP Multicast Route
Settings, as shown below:
Figure 6-159 IP Multicast Route Settings Window
The fields that can be configured in Static Multicast Route Settings are described below:
Parameter Description
Source Address
Enter the network address of the multicast source here.
Mask
Specifies the network mask for the multicast source here.
RPF Address
Enter the RPF neighbor IP address to reach the network here. Selecting the
NULL option specifies that the RPF check will always fail for multicast traffic sent
from this source network.
Click the Apply button to accept the changes made.
The fields that can be configured in IP Multicast Route Table are described below:
Parameter Description
Summary
Selecting this option specifies to display a one-line, abbreviated summary of each
entry in the IP multicast routing table.
To Next Page
Loading...
