DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
327
Parameter Description
Static
Selecting this option specifies to display the multicast static routes.
Multicast Protocol
Select this option and then select the multicast protocol that will be used in this
display here. Options to choose from are PIM-DM, PIM-SM, and DVMRP.
• PIM-DM - Specifies to display only the PIM-DM routes.
• PIM-SM - Specifies to display only the PIM-SM routes.
• DVMRP - Specifies to display only the DVMRP routes.
Group Address
Select and enter the multicast group IP address here.
Source Address
Enter the multicast source IP address here.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the entries.
IP Multicast RPF Table
This window is used to display Reverse Path Forwarding (RPF) information for a given unicast host address.
To view the following window, click L3 Features > IP Multicast Routing Protocol > IPMC > IP Multicast RPF Table,
as shown below:
Figure 6-160 IP Multicast RPF Table Window
The fields that can be configured are described below:
Parameter Description
IP Address
Enter the unicast host IPv4 address here.
Click the Find button to locate a specific entry based on the information entered.
IP Multicast Forwarding Cache
This window is used to display the content of the IP multicast routing forwarding cache database.
To view the following window, click L3 Features > IP Multicast Routing Protocol > IPMC > IP Multicast
Forwarding Cache, as shown below:
Figure 6-161 IP Multicast Forwarding Cache Window
To Next Page
Loading...
