DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
388
Figure 6-238 Route Map (Set Clauses, Edit) Window
The fields that can be configured are described below:
Parameter Description
Action
Select Add to add a new entry based in the information entered.
Select Delete to delete an entry based in the information entered.
IP Default Next Hop
Enter the default next-hop IP addresses in the spaces provided that will be used
to route the packet. This feature can be used to specify multiple default next hop
routers. If default next hops are already configured, the default next hops
configured later will be added to the default next hop list. When the first default
next hop router specified is down, the next default next hop router specified is
tried in turn to route the packet. Up to 8 default next-hop IP addresses can be
entered.
IP Next Hop
Select the IP next hop type here. This feature is used to configure the next-hop
router to route the packet that passes the match clauses of the configured route
map sequence. Options to choose from are IP Address, Peer Address, and
Recursive.
• IP Address - Specifies the IP addresses of the next-hops to route the
packet. Enter the next-hop IP addresses in the spaces provided here. Up to
8 next-hop IP addresses can be entered.
• Peer Address - Specifies the BGP peer address as the next-hop.
• Recursive - Specifies the IP address of the recursive as the next-hop router.
Enter the recursive next-hop IP address in the space provided here.
IPv6 Next Hop
Select the IPv6 next hop type here. This feature is used to configure the next-hop
router to route the packet that passes the match clauses of the configured route
map sequence. Options to choose from are:
• IP Address - Specifies the IPv6 addresses of the next-hops to route the
packet. Enter the next-hop IPv6 addresses in the space provided here.
Community
Select the community option here that will be used in the set match rule. Options
to choose from are:
To Next Page
Loading...
