D-Link DGS-3630 SERIES - Page 419

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
407
Parameter Description
• When selecting the Set-DSCP-1P option, enter the IP DSCP and 1P transmit
values in the spaces provided.
Violate Action
Select the violate action here. The violate action specifies the action to take on
packets that violate the normal and maximum burst sizes for singe rate policing. It
specifies the action to take for those packets that did not conform to both CIR and
PIR. For a single rate policer, if the violate action is not specified, it will create a
single-rate two-color policer. For a two-rate policer, if the violation action is not
specified, the default action is equal to the exceed action. Options to choose from
are None, Drop, Set-DSCP-Transmit, Set-1P-Transmit, Transmit, and Set-
DSCP-1P.
• When selecting the None option, no action will be taken.
• When selecting the Drop option, the packet will be dropped.
• When selecting the Set-DSCP-Transmit option, enter the IP DSCP value in
the space provided. This value sets the IP differentiated services code point
(DSCP) value and transmits the packet with the new IP DSCP value.
• When selecting the Set-1P-Transmit option, enter the 1P transmit value in
the space provided. This value sets the 802.1p value and transmits the
packet with the new value.
• When selecting the Transmit option, packets will be transmitted unaltered.
• When selecting the Set-DSCP-1P option, enter the IP DSCP and 1P transmit
values in the spaces provided.
Color Aware
Select the color aware option here. Options to choose from are Enabled and
Disabled. When color aware is disabled, the policer works in the color blind
mode. When color aware is enabled, the policer works in the color aware mode.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After selecting the Two Rate Settings tab option, at the top of the page, the following page will be available.
Figure 7-15 Aggregate Policer (Two Rate Settings) Window
The fields that can be configured are described below:
Parameter Description
Aggregate Policer Name
Enter the aggregate policer name here.
CIR
Enter the Committed Information Rate (CIR) value here. This value must be
between 0 and 10000000 kbps. The committed packet rate is the first token