GBC AdvancedPunch Pro 08/20/2015 Repairs/Adjustments
4-47
REP 2.14 Snap-in Bearing Replacement
PARTS LIST ON PL 3.1 and PL 3.2
Use this procedure to remove and install a Snap-in Bearing, located in
one of the following assemblies.
Entrance Idler Panel (PL 4.2)
Acceleration Roller Idler Assembly (PL 4.3)
Upper Bypass Panel (PL 4.5)
Exit Idler Panel (PL 4.4)
Lower Exit Panel (PL 3.1)
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to entire printing system.
2. Disconnect the Power Cord.
3. Do one of the following to remove the panel so you can access the
Snap-in Bearing.
REP 2.2 Entrance Idler Panel Replacement
REP 2.3 Acceleration Roller Idler Assembly Replacement
REP 2.9 Upper Bypass Panel Replacement
REP 2.6 Exit Idler Panel Replacement
REP 2.5 Punch Lower Exit Panel Replacement
4. Remove the Snap-in Bearing.
5. Place the new Snap-in Bearing in position.
6. Do one of the following to install the panel.
REP 2.2 Entrance Idler Panel Replacement
REP 2.3 Acceleration Roller Idler Assembly Replacement
REP 2.9 Upper Bypass Panel Replacement
REP 2.6 Exit Idler Panel Replacement
REP 2.5 Lower Exit Panel Replacement
7. Connect the Power Cord.
8. Power ON the entire printing system.
To Next Page
