GBC AdvancedPunch Pro 08/20/2015 Repairs/Adjustments
4-19
REP 1.18 Docking Bracket Replacement
Note: This is not applicanble for DFA configurations
PARTS LIST ON PL 2.2
Use this procedure to remove and install the Docking Bracket Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to entire printing system.
2. Disconnect the Power Cord.
3. Do GP 6.4 Undock the Punch to separate the Punch from the
upstream and downstream devices.
(Cont.)
4. Remove (2x) M3 screws to remove the Docking latch bracket.
5. Remove (1x) screw from front side of the Docking Bracket
6. Remove (2x) screws from rear side
7. Remove the Docking Bracket.
To Next Page
