GBC AdvancedPunch Pro - 2 Paper Path; REP 2.1 Lower Entrance Panel Replacement

Repairs/Adjustments 08/20/2015 GBC AdvancedPunch Pro
4-24
2. Paper Path
REP 2.1 Lower Entrance Panel Replacement
PARTS LIST ON PL 3.1
Use this procedure to remove and install the Lower Entrance Panel.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to entire printing system.
2. Disconnect the Power Cord.
3. Do GP 6.4 to undock the Punch from the upstream and downstream
equipment.
4. Do REP 1.6 Rear Cover Replacement to remove the Rear Cover.
5. Do REP 1.20 to remove the Entrance side Drive roller cover.
6. Open the Upper Bypass Assembly.
7. Remove the Screws (2) from the Front Frame used to mount the
Lower Entrance Panel.
8. Remove the Timing belt pulley shield by removing (1) screw and (1)
nut from the Rear Frame.
9. Remove the Screws (2) from the Rear Frame used to mount the
Lower Entrance Panel.
10. Remove the Lower Entrance Panel.