GBC AdvancedPunch Pro - Clear Cover Media Hole Position; Scuff Marks on Paper; Sheet Damaged at the Lead Edge of the Sheet; Wrinkle in the Sheet

Punch Quality 11/07/2018 GBC AdvancedPunch Pro
3-10
3.10 Sheet Damaged at the Lead Edge of the Sheet
1. Do RAP 3.8 to check for an obstruction of the paper path.
This clears the fault
Yes- Return to normal operation; No- Go to Step 2
2. Remove the die set and inspect the die set throat for any
obstruction.
This clears the fault
Yes- Return to normal operation; No- Escalate to 2
nd
level
3.11 Scuff Marks on Paper
1. Clean all drive and idler rollers, do
• GP 6.14.1 Idler Roller Cleaning
• GP 6.14.2 Steering Idler Roller and Springs Inspection and
Cleaning
• GP 6.15 Drive roller and Steering drive roller Inspection
and Cleaning
This clears the fault
Yes- Return to normal operation; No- Go to Step 2
2. Do RAP 4.3 to inspect Solenoids SOL 3, SOL 4, SOL 5, SOL 6,
SOL 7, and SOL 8.
This clears the fault
Yes- Return to normal operation; No- Go to Step 3
3. Do RAP 3.1 to inspect Sensors S3, S4, S5, S22, S23, and S24
This clears the fault
Yes- Return to normal operation; No- Escalate to 2
nd
level
3.12 Wrinkle in the sheet
1. If the wrinkling is at the trail edge of the sheet, Do RAP 4.1 to
check Sensor S24.
This clears the fault
Yes- Return to normal operation; No- Go to Step 2
2. Do RAP 5.3 to inspect Solenoids SOL 6, SOL 7, and SOL 8.
This clears the fault
Yes- Return to normal operation; No- Escalate to 2
nd
level
3.13 Clear Cover media hole position
1. If the hole position (Backgage and Alignment) of Clear media
differs from the hole position of plain media, do GP 6.1.5
CLEAR COVER Procedure