GBC AdvancedPunch Pro 08/20/2015 Repairs/Adjustments
4-81
REP 2.29 Upper Bypass Panel Anti-Static Brush Replacement
PARTS LIST ON PL 4.5
Use this procedure to replace the Anti-Static Brush on the Upper Bypass
Panel.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to entire printing system.
2. Disconnect the Power Cord.
3. Do GP 6.4 to undock the Punch from the downstream equipment.
4. Peel off the old Anti-Static Brush.
5. Clean the surface with some rubbing alcohol
6. Affix the new brush inside referencing the cut-outs as shown above.
7. Do GP 6.4 to dock the Punch from the downstream equipment.
8. Connect the Power Cord.
9. Power ON the entire printing system.
REP 2.30 Chip Tray Home Switch Replacement
PARTS LIST ON PL 3.5
Use this procedure to remove and install the Chip Tray Home Switch
(SW2).
1. Open the Front Door.
2. Remove the Chip Tray.
To Next Page
